My Most Messed Up 3D Print (So Far)

in Actifit3 years ago (edited)

3d-print-mess1.jpg
Image Source: Personal Photo

Believe it or not this was flat for a little while on the heat bed of my 3D printer. It's supposed to be flat. Kind of like that letter Marge Simpson wrote to Frank Gehry. Now it's a crumpled mess. Kind of like that letter Marge Simpson wrote to Frank Gehry.

It happened while I wasn't supervising my 3D printer. There was also a small glob stuck to the nozzle and a string of filament from the glob to a corner of the messed up print (pictured below). My hypothesis is that it somehow got stuck, dragged the print around the bed but the print still had some adhesion to the PEI. Evetually it was knocked off the print bed where I found it minutes later on the floor.

3d-print-mess2.jpg
Image Source: Personal Photo

This report was published via Actifit app (Android | iOS). Check out the original version here on actifit.io


2724
Daily Activity, Walking